Multi Search - FTE UNIVERS U7000 Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 103
OSD 47
OSD 48
OSD 49
OSD 50
INSTALLATION
switches.
4. On "TP Index" item use [
transponder.
5. In the "FTA Only" item, press [
free channels or even scrambled channels. If you select "Yes" it
will scan free channels only.
6. In "Scan Channel" item, press [
Radio Channels, or just TV channels or just Radio channels.
7. In "Scan Mode" item you can select "Auto Scan" to blind scan
, "Preset Scan" to scan all preset transponders or "NIT Search"
(the NIT (Network Identification) will be identified and the
receiver will automatically search all the TP of this network).
8. Move the highlight to "Search" and press [OK] button to
start scanning. Bars are showing the progress of the channel
scanning in the lower part of the window and the found channels
are listed (OSD 47).
You can stop the scan with [Exit] and save the so far found
channels.
9. Press [Exit] to exit this menu. A window to confirm the
changes will appear.

4.2. MULTI SEARCH

When you enter the "Multi Search" menu a window like the one
beside will open (OSD 48).
1. On "Satellite" item press [OK] to open the satellite list (OSD
49). Then press [
mark/unmark and [EXIT] to finish the selection. You can select
several satellites in this menu. At the bottom of the screen you
can see the selected satellites (OSD 50). The system will use
DiSEqC1.0/1.1, DiSEqC1.2 and GoToX functions to search
the marked satellites and scan channels.
2. On "FTA Only" item, press [
channels or just scanning of free channels. If you select "Yes" it
will scan free channels only.
3. On "Scan Channel" item, press [
scanning range from TV + Radio Channels, only TV channels or
only Radio channels.
4. On "Scan Mode" item, you can select "Auto Scan" to make
a blind scan , "Preset Scan" to scan all preset transponders or
"NIT Search" (the NIT (Network Identification) will be identified
and the receiver will automatically search all the TP of this
network).
5. Select "Search" and press [OK] to start scanning. In the
lower part of the window the progress of scanning and the
found channels are displayed.
6. Press [Exit] to cancel or finish the scanning and saving the
found channels.
PAG.
27
] to select the desired
] to select to scan only
] to select to scan TV +
] to move the highlight and press [OK] to
] to select scanning of all
] to select the

Publicité

Table des Matières
loading

Table des Matières