Factory Default; Upgrade By Usb - FTE UNIVERS U7000 Manuel De L'utilisateur

OSD 87
OSD 88
OSD 89
OSD 90
TOOLS

6.3. FACTORY DEFAULT

When you press [OK] on the "Default Value" item:
1. A dialogue box will occur where you need to enter the
password.
2. After you input the correct password a warning message will
be displayed like the one beside (OSD 87).
3. If you select "Yes" then all changes you made will be reset to
default values. Make sure you really want to do this!
4. Press [Exit] in both steps will close the window without
resetting the receiver.
6.4. SOFTWARE UPGRADE
It is possible to make the updating of the receiver by the means
of satellite (OTA) or by the means of USB port, and it is also
possible to make a backup of the information of the receiver in
the USB device, connected as you can see in OSD 88.

6.4.1. UPGRADE BY USB

This option allows updating the software of the receiver with the
received data from a USB memory device. To do it, connect a
USB memory device to the receiver and accede to this menu
option (OSD 89).
The last software version to be loaded must be placed at the
root path of your USB device.
1. Upgrade mode: Select with [
upgrading.
2. Update file: Select with [
loaded.
3. Select "Start" and press [OK]. An alert message appears
indicating not to take out the memory device during the loading
process.
4. Once the file has been loaded, it requires the conformity
to end the upgrading process, writing into the receiver the
upgrading. Press [OK] to upgrade the receiver (OSD 90). In
case during the reading of the file, it is corrupted or it would be
a not appropriated for this model of receiver, an alert message
would appear "Error reading the USB disk".
5. After pressing [OK] the receiver will write into the Flash
memory, and it will reboot to end the upgrading process.
For further information about the upgrading of the receivers,
please visit http://www.universbyfte.com, in the chapter about
upgrading receivers.
PAG. 38
], the mode of
], the name of the file to be