Parental Lock; Power Setting - FTE UNIVERS U7000 Manuel De L'utilisateur

SYSTEM SETUP

5.5. PARENTAL LOCK

You can set a password for anyone who wishes to operate
the "Installation" menu. You can also set the password to
lock channels. Below you find how to set and change the
password.
1. On "Parental Lock", press [OK] to open a dialogue box and
input the password. After you entered the correct password,
you will see a screen like beside (OSD 78):
2. Menu Lock: If Menu Lock is set to "Yes" then you need to
enter the password every time you want to open then menu. If
OSD 78
it is set to "No" then you can open the menu without entering
the password first.
3. Channel Lock: If set to "Yes" then you need to enter the
password before you can see those channels which have been
marked as locked channels in the Channel menu. If it is set to
"No" then even those channels can be selected without entering
the password first.
4. New menu password: The password of the installation menu
access can be modified You should do this after you set up
the receiver the first time and every time when you think that
your password is known by unauthorized persons. To change
the password, enter the new password in the "New Password"
item and repeat the same one in the "Confirm Password" item.
If the passwords are not identically then you will see a warning
message. If you entered the same new password in both fields
then you will see the message "Saving Data, Please Wait...".
From now on you need to use the new password to open locked
menus or locked channels.
New channel password: The password of the channels access
can be modified.
NOTE: The password by default in both cases is "0000"
5. Press [Exit] to leave the "Parental Lock" menu.

5.6. POWER SETTING

When you select this option, you will see a screen like beside
(OSD 79):
1. Automatic standby: In this option you can program the
automatic turning off of the receiver (OSD 80).
The programming can be made after a period of time between
1 and 8 hours, with 1 h. intervals. The default time is 3 hours.
-On: The receiver will be in standby mode automatically after
this time, as long as during this time no commands have been
sent to the receiver through the remote control or buttons of
the front panel, and no programmed timers are run.
-Off: Auto standby function gets deactivated.
2. LNB Power: If your receiver is connected to the LNB directly
then you need to set the LNB Power to "On". If your receiver is
connected to a multi switch (SMATV signal distribution system)
OSD 79
PAG. 35