Switch The Device On/Off; Selecting The Operating Mode - Roadstar CLR-725BT Manuel D'instructions

3 English
polarity (see battery compartment lid)!
•
Close the battery compartment again
WARNING:
The batteries shall not be exposed to excessive heat such as sunshine, fire
or the like. Danger of explosion!
CAUTION:
• Batteries may leak out and lose battery acid. If the device is not used for a
longer period of time, remove the battery.
• Batteries do not belong in the household waste. Dispose of spent batteries
at the designated collection points or at the dealer.

SWITCH THE DEVICE ON/OFF

Turn on the device by pressing the POWER/FUNC button. [10]
•
To turn off the device, keep the POWER/FUNC button pressed for about
3 seconds.
NOTE:
After about 20 minutes without signal, or if the signal is too low, the device will
switch to Standby automatically.

SELECTING THE OPERATING MODE

•
When the device is turned off, you can switch between radio and Blue-
tooth mode by pressing the POWER/FUNC. Button repeatedly. [10]
SETTING OF THE CLOCK (24H)
•
Hold down the TIME SET/COOK TIMER button (14) for approx. 3 se-
conds. The notification "24H" will appear in the display.
Select the time format with the SKIP+/SKIP- buttons (7/8).
NOTE:
•
"PM" will show in the display in the afternoon with the 12-hour indication.
•
Press the TIME SET/COOK TIMER button to confirm.
•
The hour setting will blink in the display.
•
Adjust the setting with the SKIP+/SKIP- buttons (7/8).
•
Press the TIME SET/COOK TIMER button for confirmation.
•
The minute indicator will flash on the display.
•
Adjust the setting with the SKIP+/SKIP- buttons (7/8).