Display Brightness; Listening To The Radio - Roadstar CLR-725BT Manuel D'instructions

•
Save the time setting by pressing the TIME SET/COOK TIMER button
again.
VOLUME ADJUSTING
Use the VOL+/VOL- buttons (9) to adjust the volume.

DISPLAY BRIGHTNESS

You can use the SNOOZE/DIMMER button (15) to adjust the brightness of
the display and of the light strip beneath the operating keys.

LISTENING TO THE RADIO

Scanning stations
•
Use the POWER/FUNC button (10) to select the radio mode.
•
Tune the desired stations with the SKIP+ (7) and SKIP- (8) buttons.
When holding down either of the buttons, the device will start scanning
until the next radio station is found. The display will show the respective
frequency.
•
If there is interference on the received station, try to improve the recep-
tion by rotating, winding or unwinding the wire antenna.
Presetting Radio Stations
The device can preset up to 30 radio stations. To preset a station, follow the
steps below:
•
Search for a station as described in "Scanning stations".
•
Press the ANSWER/PROG/AMS button (6). The display will show PRO-
GRAM and the respective preset location will begin to flash.
•
Use the PRE.+/ALARM 2 (12) and PRE.-/ALARM 1 (13) buttons to
choose the preset location for the corresponding station.
•
Press the ANSWER/PROG/AMS button again. The station will be preset.
The PROGRAM indicator and the preset location will disappear.
Recalling Preset Radio Stations
Use the PRE+/ALARM 2 (12) and PRE-/ALARM 1 (13) buttons to select the
memory locations.
Automatic station scan
Important! Any previously stored radio stations will be overwritten.
When holding down the ANSWER/PROG/AMS button (6) for approx. 3 se-
conds, the device will start the automatic station scan searching the entire
frequency range automatically for stations. The stations found will be stored
English 4