Setting The Correct Time; Listening To The Radio - Roadstar CLR-2466N Manuel D'instructions

Battery Back-up Power Failure Protection
This radio has a battery back up circuit that will keep the correct
time and alarm settings in the event of a temporary power
interruption.
Install a 9-volt battery (type 6F 22/006P), not included, into the
battery compartment located on the bottom of the unit.
Note:We recommend an alkaline battery for longer usable life.
Change the battery every 9 to 12 months for best result and avoid
possible battery leakage.
If power is temporarily interrupted the display will blink and the
radio will not play. However, the battery back-up circuit will
continue to maintain the clock and alarm settings. When power is
restored the clock will display the correct time and alarm settings,
and no adjustment is necessary.

SETTING THE CORRECT TIME

1. Press 2 seconds the TIME SET Button (9).
2. Press the TUN/TIME+ (3) or - (4) button to advance hour
3. Press 2 seconds the TIME SET Button (9) again.
4. Press the TUN/TIME+ (3) or - (4) button to advance MINUTE until the
correct time is displayed.
5. Press 2 seconds the TIME SET Button (9) to complete the setting
operation.
3
English
4
English
SETTING THE WAKE UP TIME
1. Set the alarm time by following this procedure:
2. Press 2 seconds the ALARM 1 / VOL- (6) or ALARM 2 / VOL+ (5) Button.
3. Press the TUN/TIME+ (3) or - (4) button to select BU (Buzzer) or Radio
to the activate or deactivate the alarm type (when ON, the "" indicator
will light up on the right or left side of the display).
4. Press shortly the ALARM 1 / VOL- (6) or ALARM 2 / VOL+ (5) again.
5. Press the TUN/TIME+ (3) or - (4) button to advance HOUR until the
correct time is displayed.
6. Press shortly the ALARM 1 / VOL- (6) or ALARM 2 / VOL+ (5) again.
7. Press the TUN/TIME+ (3) or - (4) button to advance MINUTES until the
correct time is displayed.
8. Press shortly the ALARM 1 / VOL- (6) or ALARM 2 / VOL+ (5) to finish.
9. Adjust the VOLUME for the best Radio level.
10. To switch off the alarm press the Power ON/OFF button (2).
11. To deactivate the alarm, press the ALARM 1 / VOL- (6) or ALARM 2 / VOL+
(5) button.

LISTENING TO THE RADIO

1. Press shortly the ON/OFF (2) button to switch the Radio ON .
2. Press 2 seconds the TUN/TIME+ (3) or - (4) button to start the Radio
auto-tuning function (the unit will search automatically the strongest
stations).
3. Adjust the VOLUME Control (5/6) to a comfortable listening level.
4. To search manually a Radio station, when in RADIO mode press the