Kenwood KDC-C521FM Mode D'emploi page 24

Troubleshooting Guide
The messages shown below display your systems condition.
EJECT: No disc magazine has been loaded in the changer. The disc magazine is not completely loaded.
➪
Load the disc magazine properly.
NO DISC: No disc has been loaded in the disc magazine.
➪
Load a disc into the disc magazine.
TOC Error: No disc has been loaded in the disc magazine.
➪
Load a disc into the disc magazine.
The CD is quite dirty. The CD is upside-down. The CD is scratched a lot.
➪
Clean the CD and load it correctly.
E-77: The unit is malfunctioning for some reason.
➪
Press the reset button on the display unit. If the "E-77" code does not disappear, consult your nearest service center.
Mecha Error: Something is wrong with the disc magazine. Or the unit is malfunctioning for some reason.
➪
Check the disc magazine, and then press the reset button on the display unit. If the "Mecha Error" code does not disappear,
consult your nearest service center.
Hold Error: The protective circuit in the unit activates when the temperature inside the automatic disc changer exceeds 60°C (140°F),
stopping all operation.
➪
Cool down the unit by opening the windows or turning on the air conditioner. As the temperature falls below 60°C (140°F),
the disc will start playing again.
ANTENNA ERR: The antenna is not connected correctly.
➪
Make sure the antenna is connected correctly and then turn OFF/ON the SIRIUS source or Display unit.
TUNER ERROR: Broadcast cannot be received due to an error in this unit.
➪
Turn OFF/ON the SIRIUS source or Control unit, or press the reset button on the Display unit.
ESN ERROR: The ESN (Electronic Serial Number) is not registered in Sirius satellite radio tuner unit.
➪
Consult your nearest service center.
LINE ERROR: Neither a disc changer nor the Sirius satellite radio tuner is connected.
➪
Connect a disc changer or the Sirius satellite radio tuner.
The number of disc changers and Sirius satellite radio tuners exceeds the limit of connection to this system.
➪
Up to two units can be connected. Rearrange your connection not to exceed the limit of the connection.
E02
E04
E77
E0d
E77
— 24 —
E77
E77
E77
E01
E99
E77