Clock Setting - Roadstar CLR-600 Manuel D'instructions

1 English
LOCATION OF CONTROLS
1. CLOCK SETTING / 12-24H SETTING
2. ALARM
3. LIGHT
4. SUNSET
5. FM RADIO ON-OFF / SCAN
6. - (DOWN)
7. + (UP)
8. NATURE SOUNDS - FM SELECTOR
9. VOLUME -
10. VOLUME +
11. SNOOZE
12. DISPLAY
13. DISPLAY BRIGHTNESS
14. DC INPUT
15. ANTENNA
16. SPEAKER
17. BATTERY COMPARTMENT
POWER SOURCE
AC POWER: To power on your product, plug the AC/DC adaptor into the DC plug (14) at the
back of the unit and into a wall AC power outlet.
Check that the rated voltage of your appliance matches your local voltage.
BATTERY BACK-UP POWER FAILURE PROTECTION
This radio has a battery back up circuit that will keep the correct time and alarm settings in
the event of a temporary power interruption. Install 2 x "LR03" batteries (not included), into
the battery compartment located on the bottom of the unit (17).

CLOCK SETTING

(The first time you plug the radio, the hour on the display will begin to blink, please proceed
directly to step 3).
When the radio is OFF:
1. Press the [CLOCK] button (1) to select 12 or 24 h;
2. Press and hold [CLOCK] button (1);
3. Use the [+ / -] buttons (6/7) to adjust the hour;
4. Confirm with the [CLOCK] button (1);
5. Use the [+ / -] buttons (6/7) to adjust the minutes;
6. Confirm with the [CLOCK] button (1).
DISPLAY BRIGHTNESS SETTING
Press repeatedly the [DISP BRIGHTNESS] (13) to select desired level (LOW, HIGH, OFF).
TO USE THE RADIO
1. Press the [FM] button (5) to power on;
2. The first time you power on the radio, press and hold the [FM] button (5) to start auto-
matic scan;
3. Use the [+ / -] buttons (6/7) to select the desired radio station;
4. Adjust the volume with the [VOL+ / VOL-] buttons(9/10) to the desired level;
5. To power off the radio, press the [FM] button (5).
Note: For a better reception reorient the antenna (15).