Automatic Storage (Log); Manual Storage (Save) - Benning CM 10-PV Notice D'emploi

5.2.2

Automatic storage (LOG)

Set the data logger to automatic storage „LOG" with predefined measuring inter-
val according to section 5.2.1. To enable the data logger, press the Bluetooth
key 7 for 2 seconds until the „
shown on the digital display K . As soon as the measuring interval is shown,
directly press the Bluetooth
10 s, 30 s or 60 s.
After having selected the desired measuring interval, the data logger starts sto-
ring measured values in the internal memory automatically after 2 seconds. If the
data logger is enabled, the symbol "
for 2 seconds to stop the data logger.
Note:
Each start of the data logger „
measured values.
5.2.3

Manual storage (SAVE)

Set the data logger to manual storage "SAVE" by pressing a key according to
section 5.2.1. To enable the data logger, press the Bluetooth
LOG
conds until the „
key 5 is pressed, the current measured value is stored in the internal memory
and the corresponding storage location number is briefly shown on the digital
display K . Manual storage is stopped by pressing the Bluetooth
2 seconds.
Note:
The first start of the manual storage "SAVE" deletes the internal memory and
thus all stored measured values of the data logger "LOG". The manual storage
„SAVE" can then be started and stopped several times. The measured values are
continuously stored in the internal memory at the storage locations 0001 to 4000.
03/ 2020
1 2
Press
LOG
key 7 to set the measuring interval to 1 s, 5 s,
®
LOG
" deletes the internal memory and thus all stored
LOG
2 Sec
LOG
2 Sec
Press
>2 Sec
" symbol on the digital display K flashes. Each time the HOLD
BENNING CM 10–PV
3
Press
Press
" symbol and the set measuring interval are
LOG
" is flashing. Press the Bluetooth
Press
>2 Sec
Wait
2 Sec
Press
Press
Press
key 7 for 2 se-
®

®
key 7
®
key 7 for
®
31