Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.4 LED lighting on Profil 740
The LED strip is power by PoE from the NTP movement. For a double sided clock the movement
of each side must be powered by its own Ethernet PoE cable. The lightning cannot be controlled.
Face B
Esclave
------
Side B
Slave
RJ12
RJ45
Double face SANS éclairage LED
Double sided WITHOUT LED strip
III - Initial startup and time setting
■ To return to the factory configuration short-circuit during several seconds (with a screwdriver
for example) the 2 pins located on the back of the clock above the label «Factory Config»
while the clock is operating.
■ To position the hands at noon short-circuit the same 2 pins when powering on the clock
(when connecting the PoE network cable).
The sweep second movement start by advancing his second hand for 10 seconds and stops to
wait for NTP synchronization.
Once the movement is synchronized, the hands move to one of the following positions: 4:00.00
or 8:00.00 or 12:00.00.
After 3 minutes the hands set themselves to the NTP time.
Indoor: HM/HMS Standard movement (ex: Profil 940)
Indoor: Sweep second movement (ex: Profil 930)
■ The default configuration is as follows (this configuration is listed on the back of the device)
- IP configuration by DHCP
- Time zone: EUR
20
Vers éclairage LED
Face A
Maitre
------
Side A
Master
RJ45
RJ12
Ethernet
Vers éclairage LED
To LED strip
To LED strip
Face B
Face A
Side B
Side A
RJ45
RJ45
Ethernet
Ethernet
Double face AVEC éclairage LED
Double sided WITH LED strip
Pins to be short-circuited
Pins to be short-circuited
- Multicast synchronisation
- Synchronisation address: 239.192.54.1
EN
Publicité
Table des Matières
