Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Problem
Water flows on the ground.
The temperature in the appliance
is too low.
The temperature in the appliance
is too high.
Replacing the lamp
Caution! Disconnect the plug from the mains
socket.
1.
Remove the screw
from the lamp
cover.
2.
Remove the lamp
cover (refer to the
illustration).
3.
Replace the used
lamp with a new
lamp of the same

Technical data

Dimension of the recess
Voltage
Frequency
Possible cause
The melting water outlet does not flow
in the evaporative tray above the com-
pressor.
The temperature regulator is not set
correctly.
The temperature regulator is not set
correctly.
The door is not closed correctly.
The product temperature is too high.
Many products are stored at the same
time.
There is no cold air circulation in the
appliance.
Height
Width
Depth
Attach the melting water outlet to the
evaporative tray.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature decrease to
room temperature before storage.
Store less products at the same time.
Make sure that there is cold air circula-
tion in the appliance.
power and specifically designed for household ap-
pliances (the maximum power is shown on the lamp
cover).
4.
Install the lamp cover.
5.
Tighten the screw to the lamp cover.
6.
Connect the plug to the mains socket.
7.
Open the door. Make sure that the light comes on.
Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to "Installation".
3.
If necessary, replace the defective door gaskets.
Contact the Service Center.
1225 mm
560 mm
550 mm
230-240 V
50 Hz
Solution
17

Publicité

Table des Matières
loading

Table des Matières