Publicité
Les langues disponibles
Les langues disponibles
Installation
When placing and installing the insect-killer, it is important to take
the location of the device in the room/space into account.
Hang the insect-killer centrally in the area; that way, the
1.
ultraviolet light can be dispersed better and attract insects from
the entire area.
Hang the insect-killer or a wall or in a corner if the room/area is
2.
not very large.
The best height for the insect-killer is 1.5 to 2 metres off the
3.
ground, which is the most common flying height for insects.
The insect-killer can be suspended from the chain or placed on a
4.
surface such as a table or cabinet. Make sure it is on a good
stable base.
Install your insect-killer in a relatively dark place , near an
5.
electricity socket: not in direct sunlight (windows, doors), because
bright sunlight weakens the insect-killer's radiation power.
Artificial light does not weaken the radiation, but makes it work
less well.
Use and Maintenance
Using for the first time
Make sure that the power socket you intend using is earthed and the
correct voltage (220-230V-50Hz). Start the insect-killer working by
plugging the device in. The insect-killer is operating.
The insect-killer can be kept switched on (24 hours a day) all year
round.
Replacing lamps
To replace a worn out UV tube you must remove the plug from the
socket and remove the collection tray by pulling it out of the side of
the device. Unscrew the 2x2 cap nuts next to the suspension eyes.
Remove the suspension eyes and top cover. Now unscrew the 2x2
screws on the front and back of the grill and lift the entire electrical
block with the lights out of grill. Unscrew the ring around the right
and left of the light fitting. Slide the rubber rings and the plastic rings
11
Publicité
