Publicité
Les langues disponibles
Les langues disponibles
ELECTRICAL
SPECIFICATIONS
1) Check available power supply and resolve any wiring problems
BEFORE installation and operation of this unit. All wiring must
comply with local and national electrical codes and be installed by
a qualified electrician. If you have any questions regarding the
following instructions, contact a qualified electrician.
2) This appliance draws 11.8 nameplate amps under Cooling Mode
and may be used in any properly wired, general purpose 15 amp
household grounded receptacle.
3) For your safety and protection, this unit is grounded through the
power cord plug when plugged into a matching wall outlet. If you
are not sure whether the wall outlets in your home are properly
grounded, please consult a qualified electrician.
WARNING: Improper connection of the grounding plug can
result in risk of Fire, Electric Shock, and/or injury to Persons
associated with the appliance. Check with a qualified service
representative if in doubt that the appliance is proplery grounded.
4) DO NOT USE PLUG ADAPTERS OR EXTENSION CORDS
WITH THIS UNIT. If it is necessary to use an extension cord with
this unit, use an approved "air conditioner" extension cord only
(available at most local hardware stores).
5) To avoid the possibility of personal injury, always disconnect the
power supply to the unit before installing and/or servicing.
POWER
The power cord supplied with this air conditioner contains a device that senses damage to
SUPPLY CORD
the power cord. To test if your power cord is working properly, you must do the following:
1) Connect the power supply cord to an electrical
outlet.
2) The power supply cord has two buttons located on
the head of the plug. One button is marked
"TEST", and the other is marked "RESET". Press
the "TEST" button; you will hear a click as the
"RESET" button pops out.
3) Press the "RESET" button; you will hear a click
as the button engages.
4) The power supply cord is now energized and
supplying electricity to the air conditioner (on
some products this is also indicated by a light on
the plug head).
IMPORTANT SAFETY INFORMATION
READ ALL SAFETY INFORMATION BEFORE USING
Suggested Individual Branch Circuit
Nameplate Amps
11.8
AWG- American Wire Gauge
*Based on copper wire at 60°C temperature rating.
Receptacle and Fuse Types
Rated Volts
Amps
Wall Outlet
Fuse Size
Time Delay Fuse
(or Circuit Breaker)
CAUTION:
unattended in a space where people or
animals cannot react to a failed unit are
located. A failed unit can cause extreme
overheating or death in such an enclosed,
unattended space.
NOTE: The power cord supplied with this air
conditioner contains a current leakage detection
device designed to reduce the risk of fire. In the event
the power supply cord is damaged, it cannot be
repaired and must be replaced with a new cord from
the product manufacturer.
• Under no circumstances should this device be used
to turn the unit on or off.
• The "RESET" button must always be pushed in
(engaged) for correct operation.
• The power supply cord must be replaced if it fails to
reset when the "TEST" button is pushed in.
2
TABLE 1
*AWG Wire Size
14
TABLE 2
125
15
15
Plug Type
Do not leave this unit
Publicité
