Maintenance - Husqvarna 435 II Manuel D'utilisation

WARNING: Be very careful when you
cut a tree that is in tension. There is a
risk that the tree moves quickly before or
after you cut it. Serious injury can occur
if you are in an incorrect position or if
you cut incorrectly.
6. If you must cut across tree/branch, make 2 to 3 cuts,
1 in. apart and with a depth of 2 in. (Fig. 92)
7. Continue to cut more into the tree until the tree/
branch bends and the tension is released. (Fig. 93)
8. Cut the tree/branch from the opposite side of the
bend, after the tension is released.
To use the product in cold weather
CAUTION: Snow and cold weather can
cause operation problems. Risk of too low
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
Maintenance schedule
Daily maintenance
Clean the external parts of the prod-
uct and make sure that there is no oil
on the handles.
Do a check of the throttle trigger and
throttle trigger lockout. Refer to
a check of the throttle trigger and
throttle trigger lockout on page 22 .
Make sure that there is no damage
on the vibration damping units.
Clean and do a check of the chain
To do a check of the
brake. Refer to
chain brake on page 21To do a
check of the front hand guard and the
chain brake activation on page 21 .
Do a check of the chain catcher. Re-
To do a check of the chain
fer to
catcher on page 22 .
Turn the guide bar, do a check of the
lubrication hole and clean the groove
in the guide bar. Refer to
check of the guide bar on page 25 .
20

Maintenance

Weekly maintenance
Clean the cooling system. Refer to
To clean the cooling system on page
26 .
Do a check of the starter, starter rope
To do
and return spring.
Lubricate the needle bearing. Refer
To lubricate the needle bearing on
to
page 25 .
Remove burrs from the edges of the
guide bar. Refer to
the guide bar on page 25 .
Clean or replace the spark arrestor
mesh on the muffler.
Clean the carburetor area.
To do a
engine temperature or ice on the air filter
and the carburetor.
1. Clothe a part of the air intake on the starter. This
increases the engine temperature.
2. For temperatures below -5°C/23°F or in conditions
with snow, a winter cover is available. Assemble the
winter cover on the starter housing. The winter cover
decreases the flow of cool air and keeps snow away
from the carburetor space. (Fig. 94)
CAUTION: Remove the winter cover if
the temperature increases above -5°C/
23°F. Risk of too high engine
temperature and damage to the engine.
Monthly maintenance
Do a check of the brake band. Refer
To do a check of the brake band
to
on page 21 .
Do a check of the clutch centre,
clutch drum and clutch spring.
Clean the spark plug. Refer to
a check of the spark plug on page
23 .
Clean the external parts of the carbu-
To do a check of
rettor.
Do a check of the fuel filter and the
fuel hose. Replace if necessary.
Do a check of all cables and connec-
tions.
To do
1270 - 002 - 30.06.2020