Husqvarna 435 II Manuel D'utilisation page 29

Note: Other chainsaw models may not meet the
kickback requirements when equipped with the listed
guide bar and saw chain combinations.
We recommend only to use the listed guide bar and saw
chain combinations.
Low kickback saw chain
A saw chain that is designated as Low kickback saw
chain, meets the low kickback requirement specified in
ANSI B175.1-2012.
Guide bar
Length, in Pitch, in
13
15
0.325
16
18
Pixel
Pixel is a guide bar and saw chain combination that is
more light weight and designated to offer more energy
efficient use by cutting narrow cuts. Both guide bar and
saw chain need to be Pixel to get these benefits. Pixel
cutting equipment is marked with this symbol.
(Fig. 144)
Filing equipment and filing angles
Using Husqvarna file gauge will give you the correct
filing angles. We recommend you to always use a
SP33G 4.8 mm / 3/16 in
H30 4.8 mm / 3/16 in
1270 - 002 - 30.06.2020
Gauge, mm/in Max. nose ra-
dius
1.3/0.050 10T
586 93 84-01
505 69 81-08
Kickback and guide bar nose radius
For sprocket nose bars the nose radius is specified by
the number of teeth, such as 10T. For solid guide bars
the nose radius is specified by the dimension of the
nose radius. For a given guide bar length, you can use a
guide bar with smaller nose radius than given.
Saw chain
Type
Husqvarna
SP33G
Husqvarna
H30
Husqvarna file gauge to restore the sharpness of the
saw chain. The part numbers are given in the table
below.
If you are not sure of how to identify what saw chain you
have on your chainsaw, please visit
www.husqvarna.com for more information.
0.65 mm / 0.030
in
0.65 mm / 0.025
in
Low kickback Length, drive
links (no.)
56
64
Yes
66
72
30° 80°
30° 85°
29