Maintenance; Troubleshooting - ShopMaster Delta S36-300T2 Guide D'utilisation

If the riving knife has vertical misalignment, adjust as
follows using FIGURE 38 and FIGURE 40:
1. Loosen the 2 hex socket head screws (AA).
2. Make adjustments to (BB2) and (BB3), to align riving
knife to the blade. No adjustment is needed for (BB1).
3. Tighten screws (AA).
If the riving knife has horizontal misalignment, adjust as
follows using FIGURE 38 and FIGURE 41:
1. Loosen the 2 hex socket head screws (AA).
2. Adjust screw (BB2) to align the riving knife to the blade,
if still out of alignment then adjust (BB3) until proper
alignment is achieved. Do not adjust (BB1).
3. Tighten screws (AA).
To reduce the risk of injury, turn unit off and disconnect it from power source before cleaning or servicing, before
installing and removing accessories, before adjusting and when making repairs. An accidental start-up can cause
injury.
KEEP MACHINE CLEAN
Periodically blow out all air passages with dry compressed air. For best performance use a shop vacuum or blower to keep saw blade
area, the dust collection system, the guarding system and rails free of saw dust and other debris. All plastic parts should be cleaned
with a soft damp cloth. NEVER use solvents to clean plastic parts. They could possibly dissolve or otherwise damage the material.
Wear certified safety equipment for eye, hearing and respiratory protection while using compressed air.
MAINTENANCE REMINDERS
Wear certified safety equipment for eye, hearing and respiratory protection while using compressed air. Gloves are recommended
when changing blades. Specific areas which require regular maintenance include:
RIVING KNIFE CLAMP PLATE: Keep this area free of dust and debris buildup. Blow out area regularly with compressed air.
NOTE: If the riving knife clamp can't move freely, have the saw serviced by authorized service center personnel.
WORM GEARS: Keep the bevel gears free of dust and debris buildup. Blow out area regularly with compressed air. Use a lithium-
based multipurpose grease as needed on these gears.
CLEAN SAWDUST BUILDUP OUT OF CABINET PERIODICALLY: NOTE: Debris can also be removed from the saw from below
the throat plate, inside the dust port.
For assistance with your machine, visit our website at www.deltamachineryparts.com for a list of service centers or call Delta Power
Equipment at 1-800-223-7278.
FAILURE TO START
If your machine fails to start, check to make sure the prongs on the cord plug are making good contact in the receptacle. Also,
check for blown fuses or open circuit breakers in your power supply line. If the saw still does not start, call Company's Customer
Care Center at 1-800-223-7278.
RIVING KNIFE ALIGNMENT

MAINTENANCE

TROUBLESHOOTING

26
CORRECT
POSITION
FIGURE 40
MISALIGNMENT
OF RIVING KNIFE
DIRECTION OF
MISALIGNMENT
FIGURE 41
DEFLECTIVE
RIVING KNIFE
BLADE