ShopMaster Delta S36-300T2 Guide D'utilisation page 11

NOTE: Make sure that stand part 1 (H) and stand part 2 (I)
are assembled in the proper orientation.
With assembled stand open, attach legs (J) to the stand using
(eight) M8 x 35mm carriage bolts (a) and (eight) M8 lock nuts
(e). Tighten lock nuts to secure legs to stand (FIGURE 3).
NOTE: Do not over tighten lock nuts.
See finished assembly of stand in (FIGURE 4).
NOTE: Legs need to correspond to correct side of stand. The
feet of the front (A) are horizontal and the feet of the rear (B)
are vertical.
Saw as assembled (FIGURE 4A and 4B).
FRONT OF STAND
ASSEMBLY
Horizontal
Feet
FIGURE 4A
H
I
CORRECT
J
REAR OF STAND
H
11
H
I
INCORRECT
FIGURE 2
e
FIGURE 3
FIGURE 4B
I
A
B
FIGURE 5
a
Vertical
Feet