Insert And Level Throat Plate; Anti-Kickback Pawls And Blade Guard - ShopMaster Delta S36-300T2 Guide D'utilisation

INSERT AND LEVEL THROAT
PLATE
Insert the rear tab of the throat plate (G) (the end with the
wear plates) under the surface of the table, and snap the front
end in place (FIGURE 13).
Check that the throat plate is properly adjusted to the table.
Front of throat plate should be level or slightly below the
surface of the table and rear of the throat plate should be level
or slightly above the surface of the table (FIGURE 13).
If adjustment is needed, adjust the (4) Phillips set screws
(FIGURE 14) up or down as needed. Repeat this process as
needed until the throat plate is level.
To remove throat plate, lower blade below tabletop, then
carefully slide the throat plate from out from the rear of the
table to the front, keeping the blade centered within the slot
on the throat plate.
It is important that the throat plate is
properly adjusted to the table. This ensures
that the work piece is not caught on the throat plate or the
table when feeding the work piece through the blade during a
cut.
To remove throat plate, lower blade below tabletop, then
carefully slide the throat plate from out from the rear of the
table to the front, keeping the blade centered within the slot
on the throat plate. (Fig. 14B)
NOTE: Zero clearance throat plate inserts are available online.
NOTE: No portion of table insert shall be above or more than
0,7 mm below the plane of the table top surface at the infeed
side and no portion of the table insert is below or more than
0,7 mm above the plane of the table top at the out-feed side.
ANTI-KICKBACK PAWLS AND
BLADE GUARD
Riving knife (E) must be in the through cut position prior to
installation of the anti-kickback pawls (D) and blade guard (F)
Insert the pawl assembly (D) into the middle slot on the riving
knife (E) as shown in FIGURE 15 while pressing the spring-
loaded pin on the right side of the pawl assembly.
Once inserted, release the spring-loaded pin so that it pops
back in to place (FIGURE 15). Ensure that it is locked in place.
To remove the anti-kickback pawls, depress the pin and pull
the anti-kickback off the riving knife.
ASSEMBLY
D
14
WEAR WEAR
PLATE PLATE
FIGURE 13
FIGURE 14
FIGURE 14b
PIN
E
FIGURE 15