Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
Wet & dry tank
1. Take out the Wet & Dry tank.
2. Separate the dust compartment from the rest of the tank.
3. Open dust compartment and empty it.
4. Use the cleaning brush to clean the inside of the dust tank.
5. Assemble the dust compartment in the Wet & Dry tank.
6. Install the Wet & Dry tank back in the robot.
7. If the Scrubbing mode has been used, empty the water tank and then fill it with clean water
to rinse it. Empty it again before installing it back in the robot.
Fig. 29
High-efficiency filter
1. Remove the high-efficiency filter and shake it to remove all the dust.
Note:
Replace the high-efficiency filter every 3 months depending on the frequency and type of use.
2. Clean the filter periodically with a brush to avoid blockage. Do not use water or detergents.
Fig. 30
Side brush
Remove and clean the side brushes regularly.
Note: In order to ensure a perfect cleaning, it is suggested to replacethe side brushes every 3
months, depending on the frequency and type of use.
Fig. 31
Free-fall sensors
Clean the free-fall sensors with a soft cloth regularly.
Warning: Always transport the product turned off and in its original package.
Fig. 32
8. BATTERY REPLACEMENT AND CHARGING
Do not use any other battery, power adapter or charging base than the one provided officially
by Cecotec.
Do not use non-rechargeable batteries.
Do not remove, dismantle or attempt to repair the battery or the charging base.
Do not place the charging base near heat sources.
Do not use a wet cloth to wipe any of the parts of this product.
If the robot is not going to be used for a long time, remove the battery from the product and
store it in a dry and safe place. It is suggested to charge the battery every month in order to
avoid damage to the battery.
42
Do not dispose of waste batteries at will. It is suggested to hand them over to professional
organizations for correct treatment.
9. TROUBLESHOOTING
Problem
The robot does not start up or does not
clean.
The robot cannot charge or return to the
charging base.
The robot does not work properly.
The robot emits a strange noise during
cleaning.
The robot does not clean efficiently or
dust leaks from the robot.
ENGLISH
Solution
The robot cannot operate with low battery.
Allow the robot to cool down before operating
it again.
The room temperature is below 0 ºC or above
50 ºC.
Operate the robot in a room where the
temperature is between the stated
temperature range.
There are too many obstacles near the
charging base, relocate the charging base to
an area free of obstacles.
Clean the charging terminals.
Make sure the power switch is turned on.
The robot is too far away from the charging
base, place it closer and try again.
There is very little free space around the
charging base. Make sure the charging
terminals are clean.
Turn the robot off, switch it off and turn it on
again.
The main brush, side brush or omnidirectional
wheel may have foreign matters tangled, stop
the robot and clear it up.
The dust tank is full. Empty it and clear the
high efficiency filter if it is blocked.
The high-efficiency filter is blocked, clear it.
The main brush is tangled with foreign matter,
please clear it up.
43
Publicité
