cecotec CONGA 5090 Manuel D'instructions page 22

ENGLISH
Spiral mode
When this mode is selected, the robot will start cleaning in a specific point, and then will clean
carrying out moves in spiral motion outwards and onwards until it reaches the starting point
with its maximum power. Then, it will be back to the base automatically.
It can only be activated from the App.
Scrubbing mode
When this mode is activated, the robot moves in a swaying motion, simulating real scrubbing
moves. It starts off cleaning in Edge mode, then in zigzag motion and finally returns to the
charging base taking the straightest way back home.
It can only be activated from the App.
Manual mode
To carry out manual cleaning, use the direction buttons on the remote control or on the App to
take the robot to the specific points where you want it to clean.
It can be activated from the App or the remote control.
Back home mode
Select this mode at any point of any cleaning cycle and during any of the modes, the robot will
automatically return to the charging base.
It can be activated from the robot, the App or the remote control.
Smart Area mode
Once the home's map has been saved, select this mode for the robot to clean a specific area
in zigzag motion. The robot will clean the selected area and then will return directly to the
charging base. You can set more than 1 area at the same time. The robot will only clean the area
selected in the map, therefore it will go to the point and return to the base without vacuuming.
It can only be activated from the App.
Spot mode
Select this mode if you want to clean thoroughly a specific point in the map, making the most
of the robot's maximum power. The robot will clean a 2x2 m zone in zigzag motion and then
will return directly to the charging base when cleaning is completed. The robot will only clean
the area selected on the map, therefore it will go to the point and return to the base without
vacuuming.
It can only be activated from the App.
Restricted Area mode
Select this mode and delimit in the map specific areas where you do not want the robot to
clean. You can set more than 1 restricted area at the same time.
It can only be activated from the App.
40
Twice mode
Use this mode to carry out a deep, thorough cleaning of your home.
It can be combined with Edge, Spiral, Spot or Smart Area modes. The robot will carry out 2 full
cleaning cycles and then will return directly to the charging base.
7. CLEANING AND MAINTENANCE
Main Brush
1. Turn the robot around and press the main brush's release button to take the cover out.
2. Take the main brush out and clean the compartment.
3. Clean the main brush with the provided tools and use water and soap if necessary.
4. Place the main brush in its position and fasten the cover's clip.
Note: Replace the main brush every 6-12 months to ensure efficient operating (depending on
the frequency and type of use).
Fig. 25
5. Main brush cover
6. Tab
7. Main Brush
8. Compartment
Silicone brush
To clean the silicone brush, follow the instructions on the previous section to remove it from
the robot and wash it with water and soap. Dry it thoroughly before installing it back to ensure
it operates efficiently.
Fig. 26
Cepillo Jalisco (brush)
To clean the Cepillo Jalisco brush, follow the previous section's steps to take it out and clean it
with water. Dry it thoroughly before installing it back to ensure it operates efficiently.
Fig. 27
Dust tank
1. Take out the dust tank.
2. Open dust tank and empty it.
3. Use the cleaning brush to clean the inside of the dust tank.
4. Install the dust tank back in the robot.
Fig. 28
ENGLISH
41