Filling Oil Tank - Remington 100271-01 Instructions D'utilisation

ASSEMBLY
Continued
Drive
Sprocket
Figure 3 - Assembling Guide Bar, Chain, and Hand Guard
Adjusting
Block
Figure 4 - Part Locations for Assembling Guide Bar
102891
Towards
Guide
Bar Nose
Guide Bar
Bolts
Guide Bar
Nuts
Sprocket
Support
Adjusting
Screw
Sprocket
Support
OWNER'S MANUAL
Cutting
Edge
Saw
Chain
Guide
Bar
Adjusting Hole
Adjusting
Plate
7

FILLING OIL TANK

1. Remove oil cap.
2. Fill oil tank with SAE #30 motor oil.
Note: For temperatures below -1°C,
use SAE #10 oil. For temperatures
above 24°C, use SAE #40 oil.
3. Replace oil cap at once. Tighten oil cap
firmly for good seal. This will avoid oil
seepage from tank.
4. Wipe off excess oil.
Note: It is normal for oil to seep when saw
is not in use. Empty oil tank after each use to
prevent seepage.