Publicité
Les langues disponibles
Les langues disponibles
Carefully square the side of the saw blade with the top
surface of the turn base using the triangular rule, try-
square, etc. by turning the 0° adjusting bolt clockwise.
Then tighten the knob firmly to secure the 0° angle you
have set.
1
► 1. Triangular rule 2. Saw blade 3. Top surface of
turn base
Check if the side of the saw blade squares with the
turn base surface once again. Loosen the screw on the
pointer. Align the pointer with 0° position in the bevel
angle scale and then tighten the screw.
45° bevel angle
NOTICE:
Before adjusting the 45° bevel angle,
finish 0° bevel angle adjustment.
Loosen the knob and fully tilt the carriage to the side
that you want to check. Check if the pointer indicates
the 45° position in the bevel angle scale.
If the pointer does not indicate the 45° position, align
it with 45° position by turning the adjusting bolt on the
opposite side of the bevel angle scale.
2
3
► 1. Left 45° adjusting bolt 2. Right 45° adjusting bolt
Adjusting the laser line position
For DLS111, DLS112 only
while adjusting the laser line. Take extra care not
to switch on the tool during adjustment. Accidental
start up of the tool may result in serious personal
injury.
beam. Direct eye exposure to the beam could cause
serious damage to your eyes.
NOTICE:
larly for accuracy.
NOTICE:
cause the laser line to be misaligned or may cause
damage to the laser, shortening its life.
NOTICE:
authorized service center for any failure on the
laser unit.
The movable range of laser line is decided by the range
adjustment screws on both sides. Perform following
procedures to alter the laser line position.
1.
2.
on the turn base. At this time, do not secure the work-
piece with a vise or similar securing device.
38 ENGLISH
1
WARNING:
The batteries must be installed
CAUTION:
Never look directly into the laser
Check the position of laser line regu-
Beware that impacts to the tool. It may
Have the tool repaired by a Makita
Remove the batteries.
Draw a cutting line on the workpiece and place it
2
Publicité
