Makita DLS110 Manuel D'instruction page 25

1
(b)
(a)
(b)
(a)
1. Inside corner 2. Outside corner
Measuring
Measure the wall width, and adjust the width of the
workpiece according to it. Always make sure that width
of the workpiece's wall contact edge is the same as wall
length.
4
► 1. Workpiece 2. Wall width 3. Width of the work-
piece 4. Wall contact edge
Always use several pieces for test cuts to check the
saw angles.
When cutting crown and cove moldings, set the bevel
angle and miter angle as indicated in the table (A) and
position the moldings on the top surface of the saw
base as indicated in the table (B).
In the case of left bevel cut
(a) (b)
1. Inside corner 2. Outside corner
(b) (a)
(a)
(b)
(d)
(c)
(a)
(b)
2
3
1
(c) (d)
1 2
Table (A)
– Molding
position
in the
figure
For
inside
2
corner
For
outside
corner
Table (B)
–
For inside
corner
For outside
corner
Example:
In the case of cutting 52/38° type crown molding for
position (a) in the above figure:
• Tilt and secure bevel angle setting to 33.9° LEFT.
• Adjust and secure miter angle setting to 31.6°
RIGHT.
• Lay crown molding with its broad back (hidden)
surface down on the turn base with its CEILING
CONTACT EDGE against the guide fence on the
saw.
• The finished piece to be used will always be on
the LEFT side of the blade after the cut has been
made.
In the case of right bevel cut
1. Inside corner 2. Outside corner
25 ENGLISH
Bevel angle
52/38° 45° type
type
(a) Left Left 30°
33.9°
(b)
(c)
(d)
Molding Molding
position in edge against
the figure guide fence
(a) Ceiling
contact edge
should be
against guide
fence.
(b) Wall contact
edge should
(c)
be against
guide fence.
(d) Ceiling
contact edge
should be
against guide
fence.
(a) (b) (c) (d)
1 2
Miter angle
52/38° 45° type
type
Right Right
31.6° 35.3°
Left Left
31.6° 35.3°
Right Right
31.6° 35.3°
Finished
piece
Finished
piece will be
on the Left
side of blade.
Finished
piece will be
on the Right
side of blade.