Publicité
Les langues disponibles
Les langues disponibles
3.
Match the pointer with your desired angle on the
scale by moving the carriage then tighten the knob.
1
2
► 1. Bevel angle scale 2. Pointer
To tilt the carriage to the right, tilt the carriage to the left
slightly and then tilt it to the right while pressing down
the releasing button.
1
► 1. Releasing button
If you perform a bevel cut greater than 45°, move the
carriage while sliding the releasing lever toward the
front of the tool. You can perform up to 48° bevel cut.
► 1. Releasing lever
This miter saw employs positive stop function. You can set
22.5° and 33.9° angle to both right and left quickly. Set the
latch lever in the position as illustrated and tilt the carriage.
To change the angle, pull the latch lever and tilt the carriage.
► 1. Latch lever
CAUTION:
After changing the bevel angle,
always secure the knob.
Slide lock
To lock the sliding movement of the carriage, push the carriage toward
the guide fence until it stops. Pull the stopper pin and rotate it 90°.
1
2
► 1. Unlocked position 2. Locked position 3. Stopper pin
16 ENGLISH
1
1
3
Publicité
