Toshiba TEC B-670 Série Mode D'emploi page 29

12. GENERAL MAINTENANCE
Cleaning the Cutter Unit
1. Be sure to turn the power off before cleaning the cutter unit.
2. The cutters are sharp and care should be taken not to injure yourself when cleaning.
1. Loosen two screws and remove the cutter cover.
2. Remove the white screw and media guide.
3. Remove the jammed paper and trash.
4. Clean the cutter with dry cloth.
White Screw
Cutter Cover
5. Assembling is reverse order of removal.
Cleaning the strip unit
Be sure to turn the power off before cleaning the strip unit.
1. Lower the backing paper release bar to remove the jammed media.
2. Clean the strip roller and backing paper holder with ethyl alcohol.
Strip Roller
Backing Paper Holder
Backing Paper Release Bar
WARNING!
Screw
Media Guide
WARNING!
E12-5
Swing Cutter
ENGLISH VERSION EO1-33016
12.4 REMOVING JAMMED MEDIA
Fixed Cutter
Cutter Unit
Fig. 12-7
Fig. 12-8