Inserting The Optional Pcmcia Card - Toshiba TEC B-670 Série Mode D'emploi

10. INSERTING THE OPTIONAL PCMCIA CARD

10. INSERTING THE OPTIONAL PCMCIA CARD (B-682 only)
WARNING:
Turn the power OFF when inserting or removing the PCMCIA card.
CAUTION:
To protect PCMCIA cards, discharge static electricity from your body by touching the printer rear
cover prior touching the PCMCIA cards.
1. Turn the power off.
2. Insert the PCMCIA card into the card slot at the rear of the printer.
3. Turn the power on.
PCMCIA Card
NOTES: 1. Be sure to protect a PCMCIA card when not in use in the printer by putting it in its protective
cover.
2. Do not subject the card to any shocks or excessive forces.
3. Do not expose the card to extremes of heat by either storing in direct sunlight or close to a
heater.
4. Do not expose the card to excessive humidity by wiping it with a wet cloth or storing it in a
damp place.
5. Before inserting or removing the card, make sure that the power switch is turned off.
6. The following PCMCIA cards can be used.
Type
ATA Card
LAN Card
Flash Memory
Card (4 MB)
7. Install the LAN card into the slot (2).
Maker
A card conforming to the PC card ATA standard
3 COM
Maxell
E10-1
10. INSERTING THE OPTIONAL PCMCIA CARD
1
2
Description
Ether Link III 3C589D PC
card
EF-4M-TB CC
EF-4M-TB DC
ENGLISH VERSION EO1-33016
Fig. 10-1
Remarks
Install into the slot (2) only.
(This card installed into the
slot (1) will not work.)