EUROM Crystal 2000 Manuel D'utilisation page 18

Remove all packaging material and keep out of reach of children. After removing packaging,
check the appliance for damage or other signs that could indicate a fault/defect/malfunction.
In case of doubt, do not use the appliance, but contact your vendor for inspection or
replacement.
Do not use the heater before it has been installed in accordance with the following
Attach the feet supplied to the underside of the heater (see picture):
Turn the heater upside down. Place a blanket (or something similar) under the heater to
prevent damage!

Attach 2 swivelling wheels (B) under each foot (C) and screw them tightly with the screws
supplied (A). see fig. 1.

Slide the feet from the sides as far as possible onto the heater, until the ball falls into the
opening, see fig. 2 & 3.

Turn the heater the right way up.

Now fix the grip (D) to the heater. To do this, remove cover cap (E) from the grip
attachment point and unscrew the screw behind (F). Now slide the end of the grip (D) into
the attachment point, matching the screw holes together. Insert screw (F) through the grip
into the screw hole and tighten it firmly. Finally, replace the cap, inserting the pins into the
holes (fig. 4, 5 & 6).

Do the same with the other end of the grip.

The grip can be positioned in six steps from horizontally forwards to horizontally
backwards. Step 3 is vertically upwards. Keep the grip at setting 2 or 4 to prevent it from
getting too hot while the heater is in operation.
instructions!
18