SOLIS 8324 Mode D'emploi page 30

34. Fill the jug and the To-Go blender cup not above the MAX
marking, otherwise the motor might be overloaded resp. the
blending performance be impaired. Also, the blended foods
might escape. Remember that some foods increase in volume
through blending.
35. Should foods cake around the blades, switch the blender off
with the turn-switch (position OFF) and pull the plug. Make
sure the motor and blades have completetly stopped before
removing the jug from the motor base. Use a plastic spatula
to break up resp. stir the foods around the blades before pro-
ceeding to blend. Do not use fingers as the blades are sharp!
36. Never use the appliance if the blades are damaged or some-
thing other than food is in the blender jug/blender cup.
37. Once the power plug has been connected to the power outlet,
you must not reach into the blender jug resp. touch the blades.
38. Keep hands, fingers, hair, clothing, jewelry and kitchen utensils
well away from the blender jug when the appliance is switched
on! Risk of injury!
39. Only if the plug is pulled and the blades have come to a stand-
still you can reach into the blender jug with your fingers, hands
or kitchen utensils! Even then, exercise extreme caution, as the
blades also are very sharp when standing still. Avoid touching
the moving parts of the blender!
40. Be careful when handling the jug as the blades are very sharp.
Be careful when emptying the blender jug and during cleaning.
Mishandling of the blades may cause injury.
41. Never remove blender jug/blender cup from the motor base
while the appliance is switched on and in use!
42. Never operate the appliance with a timer switch or a remote
control. This will prevent the appliance from switching on
automatically or accidentally, f.e. after the motor overload
protection has been triggered.
58
43. Only use the Solis Mix & Go Blender to prepare foods and/or
beverages.
44. Never use the blender without foods or liquids in the blender
jug/blender cup.
45. Do not process any hot or boiling ingredients in the blender
jug. These must be cooled down to room temperature before
being poured into the blender jug. Caution: Bubbles of hot
air might rise and splash out of hot mixtures due to steam
developing.
46. Never fill the To-Go blender cup with hot or even warm
liquids or foods. Hot and warm foods increase in volume and
might build up pressure in the cup.
47. Do not expose the blender jug/blender cup to extreme temper-
ature changes. For example, do not place a cold blender jug/
blender cup in hot water and vice versa.
48. Do not place any parts of the blender or the cup in the micro-
wave!
49. Keep the appliance clean. Always switch the appliance off and
pull the plug before cleaning and storing the appliance. Refer
to „Care and cleaning" instructions on page 73 in this manual.
50. Remove all packaging materials, package leaflets and stickers
and rinse the lid with the measuring cap seal as well as the
blender jug and the blender cup with the blade base in warm
dishwater with a soft dish rag before using the appliance for
the first time. Please refer to the section „Before first use" on
page 65 of this manual.
Caution: The blender blades are extremely sharp, avoid any
contact with your fingers resp. with your hand!
51. Never lift the blender jug/blender cup off the motor base while
the motor is running. Always turn the turn-switch to the OFF
position first and wait for the motor and the blades to come
to a complete standstill. Only then remove the blender jug/
blender cup.
59