En Instructions For Use / Assembly Instructions - Hansgrohe 13550180 Mode D'emploi / Instructions De Montage

Safety Notes
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The hot and cold supplies must be of equal pres-
sures.
Installation Instructions
• Prior to installation, inspect the product for transport
damages.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
• There must be an access door for maintenace.
It will be recommended that the faucet will be con-
nected with solid pipes.
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Thermal disinfection:
Connections G 1/2:
The product is exclusively designed for drinking water!
* In the United Kingdom, the maximum hot water
temperature and the reommended hot water temperature
can be no higher than 60° C.
4
English
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
max. 70°C*
65° C*
max. 70°C / 4 min
cold right - hot left
Assembly see page 31
Symbol description
Do not use silicone containing acetic acid!
Pipe interrupter (see page 32)
Dimensions (see page 33)
Flow diagram
(see page 33)
Rate of flow by 0,3 MPa:

Outlet 1

Outlet 2
Spare parts (see page 35)
Test certificate (see page 36)
Maintenance
The check valves must be checked regularly
according to DIN EN 1717 in accordance
with national or regional regulations (at least
once a year).
To guarantee the smooth running of the
thermostat, it is necessary from time to time
to turn the thermostat from total hot to total
cold.