Sound Settings And Setup Menu; Changing The Sound Settings - Sony MEX-BT3000P Mode D'emploi

Sound Settings and
Setup Menu
Changing the sound
settings
Adjusting the sound
characteristics
1
During reception/playback, press the
select button.
2
Rotate the control dial until the desired
menu item appears, then press it.
3
Rotate the control dial to select the
setting, then press it.
4
Press
The following items can be set:
EQ3 PRESET (page 22)
EQ3 LOW*
1
(page 23)
EQ3 MID*
1
EQ3 HIGH*
1
BALANCE
Adjusts the sound balance: "RIGHT-15"
– "CENTER" – "LEFT-15."
FADER
Adjusts the relative level: "FRONT-15" –
"CENTER" – "REAR-15."
SW LEVEL (Subwoofer Level)*
Adjusts the subwoofer volume level:
"+10 dB" – "0 dB" – "–10 dB."
("ATT" is displayed at the lowest
setting.)
22
(BACK).
(page 23)
(page 23)
2
AUX VOL (AUX Volume level)*
Adjusts the volume level for each
connected auxiliary equipment: "+18
dB" – "0 dB" – "–8 dB."
This setting negates the need to adjust
the volume level between sources.
BTA VOL (Bluetooth Audio Volume
Level)* (page 19)
4
*1 When EQ3 is activated (page 23).
*2 When the audio output is set to "SUB-OUT"
(page 23).
"ATT" is displayed at the lowest setting, and
can be adjusted up to 21 steps.
*3 When AUX source is activated (page 24).
*4 When Bluetooth audio source is activated.
Selecting the sound quality
— EQ3 Preset
You can select an equalizer curve from 7
equalizer curves (XPLOD, VOCAL, EDGE,
CRUISE, SPACE, GRAVITY, CUSTOM or
OFF).
1
During reception/playback, press the
select button.
2
Rotate the control dial until "EQ3
PRESET" appears, then press it.
3
Rotate the control dial until the desired
equalizer curve appears, then press it.
4
Press (BACK).
To cancel the equalizer curve, select "OFF"
in step 3.
Tip
The equalizer curve setting can be memorized for
each source.
3