Introduction; General Features - Bentel Security BTEL-3G Manuel D'installation

The BTEL-3G is a telephone dialler that can call a series of preset phone numbers, to which it can send both voice alarms
and text messages. The BTEL-3G is available in an ABS plastic container which is placed inside the alarm system it is
connected to. The plastic box is protected against tampering (unauthorized openings) and tearing (optional). The BTEL-
3G does not require any software to set its various options and data, but it can be programmed completely using an
alphanumeric keyboard and a voice menu that can be heard through the speaker on the baseplate.The BTEL-3G is
compatible with all alarm systems and Bentel systems belonging to the NORMA8/NORMA4, KYO, and ABSOLUTA
series. The BTEL-3G's performance depends particularly on GSM network coverage; therefore, it should not be
installed before testing several positions to get the best location for reception (at least one green LED should be on). For
optimal installation, search for the operator with the strongest signal. The BTEL-3G is equipped with:
– 4 programmable alarm inputs. When the input is activated, the dialler can send voice and text messages to up to 9
numbers.
– 4 OC (Open Collector) type outputs, 3 of which can be programmed and managed either on-site with a keyboard or remotely via
DTMF and SMS, while 1 output is reserved for signaling malfunctions (problems with the GSM network and with the SIM card).
The BTEL-3G can store 9 telephone numbers of up to 16 digits each. Voice messages can be recorded directly on the
dialler using an internal microphone and played back through a speaker on the baseplate (the microphone and the
speaker are also used for the live function).
This manual provides installation and programming of the telephone dialler. Read the User Manual supplied with the
device for operation.
     This Device is fixed and shall be installed by Service Persons only (service person is defined as a
person having the appropriate technical training and experience necessary to be aware of hazards to
which that person may be exposed in performing a task and of measures to minimize the risks to that
person or other persons). It shall be installed and used within an environment that provides the
pollution degree max 2, over voltages category II, in non-hazardous, indoor locations only. This
manual shall be used with the Installation Manual of the alarm control panel. All instructions specified
within that manual must be observed.

General Features

 Voice menu in 4 languages for programming and
use.
 4 programmable input lines.
 Up to 3 voice messages can be associated with each
event: 8 messages lasting up to 8 seconds each.
 Checking on the remaining credit for pre-paid SIM-
cards.
 Open microphone function.
 Speakerphone function.
 Sending of voice and text messages to activate input.
 Alarm call activation can be programmed with
commands and programmable polarity options (po-
sitive or negative).
 9 telephone numbers (up to 16 digits each) can be
programmed.
 Protection from accidental inversion of battery polarity.
 Power-supply voltage monitoring.
 Programmable by voice and with a keyboard.
 1 OC (Open Collector) output reserved for announcing
malfunctions.
 3 programmable OC (Open Collector) outputs.
 6 signal LED's.
 GSM Quad-Band.
 Internal antenna.
 Remote output activation through caller recognition
and/or by sending a text message.
6

INTRODUCTION

 Memory of alarm inputs for handling multiple sends.
 Priority for input n.1.
 A fourth input can be programmed to block call cycles.
 Remote call cycle blocking.
 The number of times to attempt a call can be programmed.
 The number of repetitions for an alarm message can be
 Searches for the operator with the best GSM coverage.
 Time and date programming.
 Periodic voice message.
 Periodic text message.
 Low battery indicated by text message.
 Microphone for recording messages and the live
 Speaker for listening to recorded messages and
 Superkey management.
 Digital recording and playing of messages.
 Protection from attempts at sabotage (protection against
 Housing for a 12 V - 1.2 Ah battery (not supplied).
programmed.
function.
speakerphone function.
opening and tearing).
BTEL-3G