Cleaning The Air Filter; Maintenance; Daily Maintenance - Titan PowrCoat 630 Mode D'emploi

Masquer les pouces Voir aussi pour PowrCoat 630:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Cleanup
5.3

Cleaning the air filter

The air filter blocks any debris or particles that might be present in
the supplied air from the air compressor. It is important that this filter
be checked after every use.
1. Follow the "Pressure Relief Procedure" found in the Operation
section of this manual, section 4.6.
2. Remove the top four screws that secure the front shroud. The
two screws at the bottom front do not need to be removed.
3. After the four top screws are removed, flip open the front
shroud.
4. Press the red lock release on the gray shroud (1) and turn 1/4
turn counterclockwise to remove. Be careful not to lose the
O-ring (2) that may fall out of the bowl. The clear tube may
slip off of the fitting on the bottom of the housing. It can be
reinstalled later.
5. Unthread the filter assembly from the sprayer. Be careful not
to lose the cap (3), spring (4), filter (5) or stem (6).
6. Remove and inspect the filter (P/N 0533557, 5). If dirty, clean
with warm, soapy water.
7. Prior to reassembly, tilt the sprayer on its back.
8. Make sure all parts of the filter are reassembled prior to
reinstallation (fig. 14, items 3-6).
9. Thread the entire filter assembly back into its housing in the
sprayer.
10. Make sure the O-ring (2) is in place. With the bowl inside
the shroud, insert into place and turn clockwise until the two
parts lock into place. Make sure the red lock release is facing
towards the front of the sprayer.
11. Flip the front shroud back into place and secure with the four
top screws.
3
4
5
6
2
1
PowrCoat
GB
6.

Maintenance

Before proceeding, follow the Pressure Relief
Procedure outlined previously in this manual.
Additionally, follow all other warnings to reduce the
risk of an injection injury, injury from moving parts
or electric shock. Always unplug the sprayer before
servicing!
6.1

Daily Maintenance

Two daily procedures are required for routine operator maintenance
on this sprayer:
A. Lubricating the upper packings.
B. Cleaning the inlet screen
A) Lubricating the upper Packings
1. Clean out the paint that has seeped past the upper packings
into the packing oil reservoir (fig. 15, item 1) above the fluid
section.
2. Fill the packing oil reservoir 1/2 full with Piston Lube (P/N 314-
480) supplied by the factory. This will extend packing life.
i
Do not over-fill the reservoir so that it overflows and
drips into the paint.
B) Cleaning the Inlet Screen
1. The inlet screen will clog and must be cleaned at least once a
day.
2. Loosen and remove the inlet screen (1) from the bottom of
the metal suction tube.
3. Clean thoroughly with the appropriate solvent.
13
Maintenance
1
1

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

0533630w0533630c

Table des Matières