Cleaning The Air Filter; Maintenance; Daily Maintenance; Lubricating The Upper Packings - Titan PowrCoat Série Mode D'emploi

Cleanup
11. Close the shutoff valve (fig 13, item 1). The figure shows the
handle in the closed position.
12. Close the bleed valve by turning it fully clockwise.
13. Open the shutoff valve (fig. 13, item 1). The handle should
now be in line with the valve.
Earth the gun by holding it against the edge of the
metal container while flushing. Failure to do so may
lead to a static electric discharge, which may cause
a fire.
14. Trigger the gun into the metal waste container until the paint
is flushed out of the hose and solvent is coming out of the
gun.
15. Continue to trigger the spray gun into the waste container
until the solvent coming out of the gun is clean.
i
For long-term or cold weather storage, pump
mineral sprits through the entire system.
16. Follow the "Pressure Relief Procedure" found in the Operation
section of this manual.
17. Store the sprayer in a clean, dry area.
Do not store the sprayer under pressure.
Attention
5.3

Cleaning the Air Filter

The air filter blocks any debris or particles that might be present in
the supplied air from the air compressor. It is important that this filter
be checked after every use.
1. Follow the "Pressure Relief Procedure" found in the Operation
section of this manual.
2. Unthread the filter housing (1) that is located underneath the
air motor shroud.
3. Remove and inspect the filter (2) inside the reservoir. If dirty,
clean with warm, soapy water.
4. Replace the filter in the housing. Thread the housing into
position underneath the motor shroud.
i When the filter housing is replaced properly, the
"up" arrow (s) should be visible inside the viewing
window (3).
PowrCoat
GB
6.
6.1
Two daily procedures are required for routine operator maintenance
on this sprayer:
A. Lubricating the upper packings.
B. Cleaning the filter screen
A) Lubricating the upper Packings
1. Clean out the paint that has seeped past the upper packings
into the packing oil reservoir (fig. 15, item 1) above the fluid
section.
2. Fill the packing oil reservoir 1/2 full with Piston Lube (P/N 314-
480) supplied by the factory. This will extend packing life.
i
B) Cleaning the Filter Screen
1. The filter screen will clog and must be cleaned at least once a
day.
2. Loosen the hex nut (fig. 16, item 1) that secures the filter
screen to the siphon tube.
3. Remove the filter screen (2) from the bottom of the siphon
tube.
4. Clean thoroughly with the appropriate solvent.
3
2
1
13

Maintenance

Before proceeding, follow the Pressure Relief
Procedure outlined previously in this manual.
Additionally, follow all other warnings to reduce the
risk of an injection injury, injury from moving parts
or electric shock. Always unplug the sprayer before
servicing!

Daily Maintenance

Do not over-fill the reservoir so that it overflows and
drips into the paint.
Maintenance
1
1
2