Belt Guard Assembly - Titan PowrTwin 12000 Plus Notice D'utilisation

Belt Guard assembly (P/N 0290601)
3
2
1
4
5
Item Part No. Description
1
9805329 Screw
2
0290523 Cover
3 0290600 Belt guard, rear
4 9802252 Screw
5
0290524 Bracket
6
9805255 Screw
7 0290540 Knob
8 0290794 Hinge
9
0524318 Nut
10
0290522 Guard, front
11 859-001 Washer
0290811 Label (not shown)
English
Belt Replacement Instructions
8
9
10
6
11
7
Qty.
4
1
1
IMPORTaNT: Make sure the belt is not pinched or twisted
4
in any way once you have set the gas engine / electric motor
1 back into place.
1
1
1
6
1
1
1
20
Before replacing the belt on your unit, make sure
you have performed the "Pressure Relief
Procedure" as illustrated in the user manual. DO
NOT attempt this repair while the unit is running.
NOTE: The graphics below show a unit with a gas
engine. all instructions given in this section will
apply to both gas engine models and electric
motor models except where noted.
1. Loosen the knob on the front of the belt guard. Lift open
the front end of the belt guard so that the front end of the
belt is exposed.
2. Gently lift the front end of the gas engine / electric motor.
This will loosen the tension on the belt and make it easier
to remove.
PINch haZaRD. Make sure your fingers remain
clear of the gas engine / electric motor mounting
plate.
BuRN haZaRD. Make sure the gas engine has had
time to sufficiently cool before touching it.
3. While the gas engine / electric motor is lifted up, remove
the belt from the front and rear pulleys.
4. Install the new belt:
a. Insert the belt into the fixed section of the belt guard.
Loop the belt over the rear pulley until the belt engages
the pulley groove.
b. Gently lift the front end of the gas engine / electric
motor.
c. With the front end of the gas engine / electric motor
lifted, loop the other end of the belt around the front
pulley.
d. Gently set the the gas engine / electric motor down.
The weight of the gas engine / electric motor will create
tension in the belt and prevent it from coming off.
e. Close the belt guard and tighten the belt guard knob.
Rear Belt guard
pulley (fixed section)
Knob
Belt guard
(front end)
Belt
Front
pulley
© Titan Tool Inc. All rights reserved.