Texas Hobby 300B Manuel De L'utilisateur page 14

Storage
•
If the machine is likely to be stored unused for
prolonged periods, follow the instructions below.
This will ensure longer machine lifetime.
•
Use a garden hose to wash off soil and dirt.
Remove any grass, etc. from the rotor shaft. The
chassis number should only be cleaned with a
damp cloth to avoid unnecessary wear. Avoid using
a high-pressure washer during cleaning.
•
Wipe the tiller with a damp cloth so that all surfaces
are clean. Wipe the surfaces down with an oily cloth
to prevent rust.
•
Always store the machine in a dry, clean location.
Troubleshooting
The motor will not start
1. Check the fuel control is set correctly.
2. Check the spark plug.
3. Check there is fresh gas in the tank.
4. See separate motor instructions for further
troubleshooting.
The motor is not running smoothly
1. Ensure the throttle control is not set to max.
2. Check there is fresh gas in the tank.
Specification
Model
Length (mm)
Width (mm)
Height (mm)
Weight (kg)
Forward gears
Reverse gears
Handle
Working width
Working depth
Rotation speed,
blades
Grease type
Brand
Model
Capacity
Max power
Sound power level of
machine
Hobby 300B
1210
510
1020
28
1
0
Adjustable
38 cm
20 cm
130 rpm
B&S
B&S 450
148 CC
1,89kW/ 3200rpm 2,04kW/ 3200rpm
L : 93 dB(A)
WA
The blades will not rotate
1. Check for stones lodged between the blades.
2. Release any stones by removing the blades.
3. Check the cables are in good working order and
fitted correctly.
4. Check the belt is in good working order and fitted
correctly.
5. Ensure the belt tensioner is adjusted correctly.
The blades will not stop
Stop the engine and contact your dealer.
Noise, vibration and precautionary measures
1. Long-term exposure to noise levels exceeding 85
dB (A) are damaging. Always use ear defenders
when the machine is being used.
2. Reduce the running speed of the motor to reduce
vibration and noise levels.
3. To reduce noise levels further, only use the machine
in an open environment.
4. Vibrations can be reduced further by holding the
handle firmly.
5. To avoid disturbing others, the machine should only
be used during the daytime.
6. Always wear close-fitting work clothes, hard-wearing
work gloves, ear defenders and non-slip boots with
steel toecaps.
7. Take a 30-minute break every 2 working hours.
8. A worn belt has to be replaced/ serviced by a
authorized dealer
Hobby
Hobby 400B Hobby 480BR
1210
510
1020
28
1
0
Adjustable
38 cm
20 cm
130 rpm
Multifak EP-0
Engine
B&S
B&S 500
158 CC
2,04kW/ 3200rpm
L : 93 dB(A) L
WA WA
10
Hobby 380TG
1210
510
1020
28,5
1
1
Adjustable Adjustable
38 cm
20 cm
130 rpm 130 rpm
B&S PowerLine
B&S 500 TG385
158 CC 113 CC
1.45kW/ 3200rpm
: 93 dB(A) L : 93 dB(A)
WA
1210
510
1020
28
1
0
38 cm
20 cm