Seca 720 Mode D'emploi Et Garantie page 16

Power supply
The scale is powered exclusively by batteries.
The LC display has a low power consumption – 8.000 weighing operations can be per-
formed with one set of batteries. When
change the batteries. You require 4 AAA-type 1.5 V batteries.
All the illustrations are on the foldout flap at the front.
– Carefully turn over the scale so that the
base of the scale is accessible (see
Fig. 3).
– Push the battery compartment closure
towards "Battery" and open the cover.
– Insert the new batteries in the battery
compartment.
Switching the weight display
The weight display can be switched between kilogrammes (kg) and pounds (lb) or be-
tween kilogrammes (kg) and stones (st) (see Fig. 8). Once you switch back on, weighing
will be performed using the new unit of measurement.
4. Setting up and aligning the scale
– Place the scale on a level surface.
– Ensure that only the feet of the scale
are in contact with the floor. The scale
5. Operation
Simple Weighing
– Step gently onto the scale (see Fig. 4).
The vibration switch starts the scale.
and
se(a 0. 0 0
the display. The scale is then automati-
cally set to zero and ready to use.
– If necessary, switch the weight display
(see "Switching the weight display" on
page 15).
– Stand on the scale and keep still.
Once weight has been determined, the
Note:
The scale also has a "Step Off" function (see Fig. 5): you can also step straight onto the
scale when it is switched off and the scale starts measuring as soon as it is switched on.
If is displayed, get off the scale again. The scale now determines the zero
Step 0ff
point, after which the measured values are shown in the display.
Model 720/818
appear consecutively in
or appear in the display, you should
bAtt
Check that the polarity is correct.
– Close the cover.
– Then turn the scale back up the right
way.
may not be in contact at any other
point.
scale will also try to measure body com-
position, which can be seen by the sym-
bol o moving across the display. You
can now simply get off the scale (the
scale will briefly show an error message).
– Read the weighing result off the digital
display.
– If a load greater than 180 kg (396 lb/
28:5 st) is placed on the scale,
appears in the display.
St0P
GB
15