Tylo Sense Ples Notice D'installation page 18

Unscrew the first two screws on the back of the heater and
screw one of the four brackets into place. Repeat the pro-
cedure until all of the brackets are fitted see Figure 9, Page
5.
Figure 9: Attaching the brackets to the heater
9. Position the bracket screws according to the specified dimen-
sioning see Figure 10, Page 5.
4
3
2
Figure 10: Dimensioning
1. 262 mm
2. 270 mm
3. 532 mm
4. 206 mm
10. Attach the herb bowl/air humidifier (see Figure 11, Page
5).
Figure 11: Installing the fragrance holder/air humidifier
11. Hang the heater on the screws se Figure 12, Page 5.
Figure 12: Hang the heater up.
12. Lock the heater into place with the lock screw see Figure 13,
Page 5.
1
Figure 13: Lock screw for bracket
13. Install the sensor on the wall see . Tighten the screws care-
fully to avoid breaking the circuit board.
Figure 14: Installing the sensor
Unusual voltages/numbers of phases
Before connecting to voltages or numbers of phases not listed in
the wiring diagram Figure 15, Page 6, contact Tylö Customer
Service.
5