Chin Strap Micrometric Buckle - shark NANO Manuel D'utilisation

CHIN STRAP MICROMETRIC BUCKLE

HOLDING SYSTEM
Depending on the various versions and the
country concerned, your SHARK Nano helmet
is equipped with a chin strap with a "Precise
Lock" rapid buckle with a snap lock.
The "Precise Lock" snap lock system gives you
precise and accurate adjustment because of
the considerable length of its notched section.
However, it is essential on purchase to adapt the
length of the chin strap to your measurements.
Adjust the length of the strap using the adjusting
buckle (Figs. A, B, C and D).
CHIN STRAP MICROMETRIC BUCKLE
Choose your SHARK Nano and attach the holding
system. When the "Precise Lock" is adjusted to
the medium position, the chin
strap must be correctly tensioned under the chin
A A
A
to hold the helmet firmly without causing you any
discomfort or pain. To fasten the chin strap, all
you have to do is to thread the tongue into its
place on the buckle until tension is perfect (Fig.
B). The tongue connects and is automatically
blocked. To release the chin strap, you have to
pull on the lever and remove the tongue from the
buckle. Although the notched tongue enables you
to change the adjustment precisely on each use,
it is important to check frequently that the adjust-
B
B ment of the strap length is correct.
B
WARNING: never ride with the chin strap
loose or insufficiently tightened. Even
though the interior padding gives you the
impression of being held, your helmet risks
coming off in a fall.
Never apply lubricating or acid products
or grease or solvents to the chin strap
buckle parts.
C
C
C
C
9
D
D
D
E
E
E