Typical Venting Installation - Napoleon Ascent Séries Manuel D'installation

Linéaire. modèles de gaz naturel, modèles de propane. pour usage intérieur seulement
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

venting requirements
EN
These vent kits allow for either horizontal or vertical venting of the appliance. The maximum allowable horizontal run is 20
feet (6.1m). The maximum allowable vertical vent length is 40 feet (12.2m). The maximum number of vent connections is two
horizontally or three vertically (excluding the appliance and the air terminal connections) when using fl exible venting.
Horizontal runs may have a 0" rise per foot or 0mm rise per meter however for optimum performance it is recommended
that all horizontal runs have a minimum 1/4" rise per foot or 21mm rise per meter using fl exible venting. For safe and proper
operation of the appliance, follow the venting instructions exactly.
A terminal shall not terminate directly above a sidewalk or paved driveway which is located between two single family dwellings
and serves both dwellings. Local codes or regulations may require different clearances.
Do not allow the inside liner to bunch up on horizontal or vertical runs and elbows. Keep it pulled tight. A 1¼" (31.8mm) air gap
all around between the inner liner and outer liner is required for safe operation.
3.1

typical venting installation

16" (40.6cm)
MINIMUM
f i r e - p a r t s . c o m
40 FT (12M)
MAXIMUM
18" (45.7cm)
3 FT (1M)
MAXIMUM
MINIMUM
12 7/8"
(32.7cm)
MINIMUM
46" (116.8cm)
MINIMUM
PLUS RISE *
*See "venting requirements" and "venting installation" sections
13
W415-1705 / G / 03.21.19

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ascent bl36nte-1Ascent bl46nteAscent bl36pte-1Ascent bl46pte

Table des Matières