Napoleon Ascent Séries Manuel D'installation page 41

WARNING
!
• Risk of fi re!
• Never obstruct the front opening of the appliance.
• The front of the appliance must be fi nished with any non-combustible materials such as brick, marble, granite,
etc., provided that these materials do not go below the specifi ed dimension, as illustrated.
• Do not strike, slam, or scratch. Do not operate appliance with glass removed, cracked, or scratched.
• Facing and/or fi nishing material must never overhang into the appliance opening.
• The glass door assembly is designed to pivot forward when relieving excess pressure that might occur. Finishing
or other materials must not be located in the opening surrounding the door as this will interfere with the doors
ability to relieve pressure.
11.1 anti condensation switch
This appliance has the option to change from an electronic intermittent pilot ignition (IPI) to a standing pilot for
colder climates. The anti condensation switch (ACS) (standing pilot) is located in the center of the control panel.
If installed with the blue wire facing up, fl ipping the switch UP turns on the standing pilot and fl ipping the switch
DOWN turns on the intermittent pilot ignition. If installed with the white wire facing up, the opposite is true.
Turning the ACS on will allow the pilot fl ame to burn continuously. This mode will minimize the
condensation which forms on the inside of the glass when the main burner is fi rst turned on. It will also help
the fi replace and vent system stabilize faster during colder winter months.
f i r e - p a r t s . c o m
During the warmer winter and summer months, the ACS can be turned off to minimize fuel consumption.
11.2 control cover installation
Slide the back edge of the control cover down between the glass and the door frame. Insert downwards.
11.0 fi nishing fi nishing
W415-1705 / G / 03.21.19
EN
41