Shindaiwa B530 Manuel D'utilisation page 19

1. Shaft bolt
2. Bolt guard
3. Holder B
1. Safety clip
2. Holder A
1. Blade
4. Safety clip
5. Holder A
6. Gear shaft
3. Blade
Before you start
1. Turn the product over so the saw holder flange extending
from the gear case is facing up.
2. Using the small end of the socket wrench, loosen the bolt
(turn clockwise) and remove the bolt, bolt guard, and holder
B.
3. Slide the safety clip off-center.
4. Fit the blade over the safety clip onto holder A. Then, slide
the safety clip back to its original position.
Install the blade so its printed surface is visible to the
operator when the brushcutter is in the normal operat-
ing position.
The blade must fit flat against the holder flange. The
blade mounting hole must be centered over the raised
boss on blade holder A.
5. Put holder B and bolt guard back and at this time only finger
tighten the bolt. Make sure holder B is flat against the blade.
The recess in holder B must face the blade and completely
cover the safety clip.
17
CAUTION
WARNING