Shindaiwa B530 Manuel D'utilisation page 18

Before you start
Cutting attachment shield assembly
1. Socket-head cap
Screw
2. Bracket
3. Shim
4. Clamp screw
5. Outer tube
1. Cutting attachment
shield
2. Hook receiver
Installing a blade
Do not attempt to fit the trimmer blade with one hand or without using the socket spanner. Fit the trimmer blade ac-
curately using the supplied socket spanner and tighten firmly in position.
The trimmer must not be used if the blade vibrates or is loose.
Wear heavy duty gloves when working with the trimmer blade. When replacing the trimmer blade during a trimming
task, ensure that the engine is switched off and that the blades have stopped.
Do not use any tools other than the proved socket spanner to tighten the blade, a pneumatic or electric tool may
tighten the blade more than necessary and cause the nut or the output shaft to break.
When turning the product over to replace the trimmer blade, ensure that the fuel tank cap is securely in place.
Failure to do so could lead to an injury or serious accident, or cause a fire.
6. Cutting attachment
shield
7. Shim
8. Cutting attachment
shield mounting plate
9. Retaining nut
3. Sub-shield
4. Hook
WARNING
Cutting Attachment Shield
1. Insert the cutting attachment shield between the outer tube
and the cutting attachment shield mounting plate.
NOTE
It may be necessary to loosen the retaining nut and clamp
screw to adjust cutting attachment shield mounting plate.
2. Fit the two shims and the bracket over the outer tube and
loosely install the four socket-head cap screws.
3. Tighten the four socket-head cap screws to secure the cut-
ting attachment shield.
Make sure the clamp screw and retaining nut are securely
tightened before tightening the four socket-head cap
screws.
Sub-shield (when trimmer head is in use) (Consult
your dealer.)
1. Attach the shield extension to the cutting attachment shield.
Never use this product without sub-shield when using a
trimmer head.
Make sure the sub-shield is completely hooked at the
hook receiver.
16
CAUTION
WARNING
CAUTION