Hendi Display Line Série Mode D'emploi page 5

the user could get hot when in close proximity to the heating surface.
• Caution! Securely route the power cord if necessary in order to prevent unintentional
pulling or contact with the heating surface.
• Do not wash the appliance with water. Washing can cause leakages and increase the risk
of electric shock.
• Do not clean or store the appliance unless it is completely cooled down.
• Do not place empty cookware on the appliance during operation as this may damage the
cookware.
• Only use the cookware of the type and size recommended. (See - - -> Suitable cooking
equipment).
Grounding installation
This appliance is classified as protection class I
appliance and must be connected to a protective
ground. Grounding reduces the risk of electric
shock by providing an escape wire for the electric
1 2 3
Touch control panel of the appliance
1) On/Standby button
2) Timer function with indicator light
3) Increase setting: Time / temperature / power
4) Digital display
5) Decrease setting: Time / temperature / power
Preparations before using for the first time
• Remove all protective packaging and wrapping.
• Check to make sure the appliance is undamaged.
In case of incomplete delivery and damages.
Please contact supplier (See == > Warranty).
• Clean the appliance before use (See == > Clean-
ing and Maintenance).
• Make sure the appliance is completely dry.
• Place the appliance on a horizontal, stable and
heat resist surface that is safe against water
splashes.
4 5 6 7
current. This appliance is equipped with a cord
having a grounding wire with a grounding plug. The
plug must be plugged into an outlet that is properly
installed and grounded.
8 1 2 3
6) Power function with indicator light
7) Temperature function with indicator light
8) Boost function to increase power (Right: 2,000W;
Left: 1,500W)
• Ensure that there is sufficient ventilation. Keep
a minimum distance of 15 cm around the appli-
ance.
• Do not place the appliance in close proximity to
devices which are sensitive to disturbances by
magnetic sources (e.g. radios, tape decks).
Note: Due to manufacturing residues, the appli-
ance may emit a slight odor in the first few cycles.
This is normal and does not indicate any defect or
hazard. Make sure the appliance is well ventilated.
4 5 6 7
EN
5