Abus TVAC19000A Notice D'utilisation page 31

Warnings
Observe all safety and operating instructions before putting the device into operation for the first time.
1. Observe the following information to avoid damage to the power cable and plug:
• Do not modify or manipulate the power cable or plug.
• Do not pull the cable when disconnecting the device from the power – always take hold of the
plug.
• Ensure that the power cable is positioned as far away as possible from any heating
equipment, to avoid melting the plastic coating.
2. Follow these instructions. Non-compliance with these instructions could lead to an electric shock:
• Never open the housing or power supply unit.
• Do not insert any metallic or flammable objects into the device.
• Use surge protection to prevent damage caused by overvoltage (e.g. in electrical storms).
3. Disconnect defective devices from the power supply immediately and contact your specialist dealer.
If in doubt, have a specialist technician carry out assembly, installation and connection of the
device. Improper or unprofessional work on the power supply system or domestic installation
puts both you and other persons at risk.
Connect the installations so that the mains power circuit and low-voltage circuit always run
separately from each other. They should not be connected at any point or become connected
as the result of a malfunction.
Avoid the following adverse conditions during operation:
•
moisture or excess humidity
•
temperatures outside of the permissible range
•
direct sunlight
•
dust or flammable gases, vapors or solvents
•
strong vibrations
•
strong magnetic fields (e.g. next to machines or loudspeakers)
Unpacking the device
Handle the device with extreme care when unpacking it.
If the original packaging has been damaged, you must start by inspecting the device. If the
device shows signs of damage, return it in the original packaging and inform the delivery
service.
31
English