Qlima Fiorina 74-2 S-line Manuel D'installation page 110

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 198
4.
5.
6.
7.
8.
9. ELECTRICAL CONNECTIONS
This stove requires an electricity supply. Carefully read the instructions below. The
stove can only be connected to the mains when all other installation operations
have been completed. Read chapter 3 and 3.1 of the user manual before connect-
ing the stove to the mains.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
9.1 WIRING DIAGRAM
Figure 14:
1.
2.
3.
4.
5.
4
110
The stove is designed for free installation and is unsuitable for flush mount-
ing.
Make sure that the grille from which the heated air comes out is free and
unobstructed.
Make sure that the return air intake grille is not blocked.
If the floor is made of flammable material, the stove must be placed on a
fire-resistant slab. The dimensions of this slab must be greater than 40 cm at
the front and sides, and 20 cm at the back compared to the perimeter of the
stove.
Position the stove in such a way that it can easily be accessed for mainte-
nance purposes.
Make sure that the mains voltage matches that of the device indicated on
the type plate.
Use only a grounded socket. In its absence, a grounded socket must be in-
stalled by an authorised installer.
Do not use an extension cable to connect the stove. In the absence of a
grounded socket, it must be installed by an authorised installer.
Make sure that the extension cable does not come into contact with hot
parts of the stove.
A part of the extension cable supplied must be connected to the stove, see
figure 13.
Make sure the extension cable plug fits in the socket.
Before inserting the plug into the socket, make sure that the socket and the
connection cable are intact.
Make sure that the power switch at the back of the stove is turned OFF.
Make sure that the plug is easily accessible so that it can be disconnected
quickly and easily from the socket for maintenance purposes, or in an emer-
gency.
Do not attach the cable.
Buig en knik de kabel niet.
Any damaged power cord or plug should only be replaced by the
supplier, a competent technician or an authorised service technician.
Room temperature sensor
Combustion gas pipe sensor at room temperature
Combustion gas pipe differential pressure switch
Safety thermostat
Pellet screw transmission

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Fiorina 90-2 s-lineThelma 74 s-line

Table des Matières