Home Connect Settings - NEFF T18TS2KN Série Notice D'utilisation

Set the value to using the twist knob.
ƒ
4.
and the symbol will flash on the hotplate
ƒ D
display.
Use the SSID "Home Connect" and the key "Home
5.
Connect" to log your mobile device into the hob
network.
Once the D symbol stops flashing and remains lit
continuously on the hotplate display, the hob is
connected to your home network.
The appliance will automatically try to connect to the
app; the setting will appear. The value
•'ƒ
flash in the settings area.
Launch the app on your mobile device and follow the
6.
instructions for manually logging into your network.
Once the value appears on the hotplate display, the
‹
login process is complete.

Home Connect settings

You can adjust Home Connect to suit your
requirements at any time.
In the basic settings for your hob, navigate to the Home
Connect settings to display network and appliance
information.
Symbol
•'‚
‹
‚
ƒ
„
•'ƒ
‹
‚
•'„
‹
‚
•'...
‹
‚
•'†
‚
ƒ
•'‡
‹
‚
•'ˆ
‹
‚
will
‚
ƒ
„
•'‰
‹
‚
* Basic setting
Notes
The •'ƒ
■
connected to the home network.
The •'„
■
has once connected to a network.
The
•'†
■
available.
The
•'‡
■
Service is attempting to connect to the appliance.
You can end this at any time after granting access.
The
•'ˆ
■
there is a connection to WLAN.
Function
Registration in the home network (WLAN)
Not connected /disconnect network.
Connect automatically.
Connect manually.
Connected.
Connection to app
Not connected.
Connect.
Connect to WLAN
Radio module switched off.
Radio module switched on.
Settings via app
Switched off.
Switched on.*
Software update
Update available and ready for installation.
Starting installation.
Remote access by Customer Service
Not permitted.
Permitted.
WLAN signal strength
Not connected to home network (WLAN).
Signal strength 1 (poor)
Signal strength 2 (moderate)
Signal strength 3 (good)
Connection to Home Connect server
Not connected.
Connected.
setting is only displayed if the appliance is
setting is only displayed if the appliance
setting is only displayed if an update is
setting is only displayed if Customer
and settings are only displayed if
•'‰
Home Connect
en
63