Replacing The Carbon Filter (Hse 159 Ix); Lamp Replacement; Electrical Connection; The Guarantee - SCHOLTES HP Série Mode D'emploi

to the one for dismounting).
GB
Fig. 3
Fig. 4

Replacing the carbon filter (HSE 159 IX)

The carbon filter (fig. 3) is used to remove grease and
odours from the air before it is released back into the
room through the upper grille.
The carbon filter may be washed every two months,
using hot water and suitable detergent or a dishwasher
cycle at 65°C (if cleaned in the dishwasher, run an entire
cycle when no crockery is inside).Remove excess water
without damaging the filter, then remove the matting
inside the plastic frame and place the filter in the oven
at 100°C for 10 minutes to dry it thoroughly.
Replace the active carbon filter every three years or if
it is damaged
To fit or replace the carbon filter:
Remove the grease filter(s).
Fit the grease filter(s).

Lamp Replacement

For the HSE 159 IX model only: call technical
assistance service. For the other models:
disconnect the appliance from the electricity supply.
a. Remove the cover of the recessed lamp by using a small
screwdriver to lever it out (Fig. 5).
b . Replace the faulty lightbulb with an identical one.
c. Replace the lamp cover.
d. If the lighting system does not work, make sure the lamps
have been inserted correctly before contacting the technical
assistance service.
12
E
O
Fig. 5

Electrical Connection

This hood is intended for a fixed permanent installation.
For the mains voltage and frequency information,
consult the serial number plate situated inside the
appliance. The power supply cable (type H05VV-F
3x0.75 mm ²) connected to the hood's terminals marked
"L" (mains), "N" (neutral) and fastened by means of
the cable clamp must be connected to a suitable and
accessible fixed power point by specialised and
authorised personnel, who are to install the hood in
compliance with the norms and laws in force, providing
for an omnipolar switch above the electrical connection
with a minimum contact opening of 3 mm. The
manufacturer will not be held responsible should all the
accident-prevention norms in force and necessary for
the normal and regular operation of the electrical system
fail to be observed.

The Guarantee

The appliance should reach the purchaser provided with
not only this instruction booklet but also the
GUARANTEE CERTIFICATE. Should the latter be
missing, then DEMAND IT.
For the guarantee to be effective, the purchaser should
ask the retailer to validate the guarantee certificate by
stamping it and dating it with the date of purchase in
the space provided.
THE GUARANTEE CERTIFICATE NEED NOT BE
POSTED FOR VALIDATION.
Should this procedure fail to be observed, the technical
staff shall be forced to CHARGE the purchaser for any
repairs.
For any malfunctions during the operation of the hood,
the purchaser can contact the Retailer where the
appliance was bought or his/her nearest Authorised
Service Centre.
HELP US SERVE YOU BETTER: please read the
guarantee clauses herein.