Connecting Via A Usb Cable; Setting A Paper Size And Type; Specifying Initial Fax Settings And Connecting A Telephone Cable (Imagerunner 1435If Only) - Canon imageRUNNER 1435i+ Mode D'emploi

Connecting via a USB Cable

Connect the USB cable after installing the drivers.
1
Download the appropriate drivers from the Canon
website (http://www.canon.com/).
2
Install the drivers on your computer.
For details on the installation procedures, see the driver
installation manuals that are included with the drivers.
3
Connect the USB cable.
Proceed to "Setting a Paper Size and Type" (P.7).

Setting a Paper Size and Type

Follow the instructions on the screen to set the paper size and
type.
Specifying Initial Fax Settings and
Connecting a Telephone Cable
(imageRUNNER 1435iF Only)
1
Specify the initial fax settings.
Follow the instructions on the screen to specify a fax number,
a unit name, and a receive mode. When selecting the receive
mode, refer to the e-Manual for details about each mode.
e-Manual "Faxing (imageRUNNER 1435iF Only)" ▶
"Receiving Faxes"
How to use a user name
When you send a document, the sender information that
you registered is printed on the recipient's paper.
Selecting <Set Up Later>
If you select <Set Up Later>, the receive mode is set to
<Auto>. Later, when you want to confi gure the fax
settings, display the fax setup screen by pressing
▶ ▶
<Fax Settings> <Fax Setup Guide>.
2
Connect a telephone cable.
B
A
When <Connect Telephone Line> appears on the display,
connect the telephone cable by referring to the illustration.
3
Exit the fax setup screen, and then restart the
machine.
Turn OFF the machine and wait for at least 10 seconds
before turning it ON again. If the telephone line types are
not detected automatically, see the e-Manual and set a
telephone line manually.
e-Manual "Setting Menu List" ▶ "Fax Settings (imageRUNNER
1435iF Only)" ▶ "Basic Settings" ▶ "Select Line Type"
▶
Telephone
Telephone line connector
En
7