Toto THU669 Manuel D'installation Et Guide D'utilisation page 5

• To ensure sanitary use of the product,
always wash the tank and wand (pour
water through the wand to clean it)
before each use.
• After filling the tank with water, do not
leave the wand hanging loose from the
end of the tank to avoid water leakage.
Using the travel washlet:
1. Pull out the wand.
2. Wrap the carrying strap around your wrist
to avoid dropping the device and hold
the Travel Washlet with the switch facing
upward [See drawing].
3. Position the Travel Washlet so that you
can reach the area to be washed from the
front of your body or at an angle from the
rear and push the switch.
* Be sure to use all of the water in the tank to
avoid water leakage after use.
WARNING: Do not insert the wand into the
body. Doing so could result in injury.
Switching the water pressure from high to
low: Grasp the sides of the wand cover and
slide the cover off until it clicks into the desired
position. Slide the wand cover forward to the
3rd hole for standard water pressure or the
HIGH setting, and backward to the 5th hole for
soft water pressure or the LOW setting.
Standard Water Pressure
(HIGH)
Soft Water Pressure
(LOW)
OPERATIONAL PROCEDURE
LOW
From the
front
HIGH
5
At an angle
from the rear
Wand
Wand Cover
(3 holes)
(4 holes)