ResMed Quattro Air Mode D'emploi page 13

Daily/After each use:

Disassemble the mask components according to the disassembly
instructions.

Thoroughly clean the separated mask components (excluding
headgear), by gently rubbing in warm (approximately 30°C) water
using mild soap.

To optimise the mask seal, facial oils should be removed from the
cushion after use.

Inspect each component and, if required, repeat washing until visually
clean.

Rinse all components well with drinking quality water and allow to air
dry out of direct sunlight.

When all components are dry, reassemble according to the
reassembly instructions.
Weekly:

Handwash the headgear. It may be washed without being
disassembled.
Reprocessing the mask between patients
This mask should be reprocessed when used between patients. Cleaning,
disinfection and sterilisation instructions are available from the ResMed
website, www.resmed.com/masks/sterilization. If you do not have
internet access, please contact your ResMed representative.
English 5